Epoxy.com Product #490
Foot Traffic, Driveway, and Athletic Surface
PRODUCT DESCRIPTION
INSTALLATION
Smooth surfaces must be sanded to roughen the texture for proper adhesion.
Concrete surfaces must be clean and sound, but need not be thoroughly dry. Slick
concrete surfaces require acid washing, neutralizing and flushing prior to
application to insure positive adhesion. Bare metal must be primed prior to
coating. Do not apply PRODUCT #490 at temperatures below 50oF (10oC). Stir
thoroughly before use. Apply PRODUCT #490 with brush, roller, or squeegee at a
rate of 150 - 160 sq. feet per gallon (3.70 - 3.90 m2/liter), two coats minimum.
Allow 4 hours drying time between coats. Allow a minimum of 12 hours drying
time, at normal temperatures, before opening area to light pedestrian traffic.
Clean Up: Brushes and rollers may be cleaned with soap and water
immediately after use, followed by a rinse in paint thinner or solvent to remove
any oil residue.
PRODUCT WARRANTY
All products proven to be defective in manufacturing will be replaced at no
charge. Since the use of these products is beyond our control we cannot assume
any risk or liability for results obtained, nor can we accept damages in excess
of the purchase price of these products.
MAINTENANCE
TECHNICAL DATA
Property |
Test method |
Results |
Consistency |
--- |
Liquid |
Weight per Gallon |
--- |
11.60 pounds |
Coverage rate |
--- |
150 - 160 sq. ft. |
Viscosity at 77oF (25oC) |
Brookfield Viscometer |
70 ± 10 poise |
Percent Solids |
ASTM D-2369 |
|
Dry to Touch at 77oF (25oC) |
Observed |
2 hours |
Recoat Time at 77oF (25oC) |
Observed |
4 - 5 hours |
Cure Time at 77oF (25oC) |
Observed |
24 - 36 hours |