Epoxy.com'™ Product #1W

100% Solids Hi-Build Epoxy Coating


GENERAL DESCRIPTION

Product #1W - epoxy coating for walls, is a two component, 100% solids epoxy Hi-Build epoxy wall coating used for high indoor traffic areas where abrasion resistance is required; for protection against mild corrosion; and as a decorative waterproof coating for walls, tanks, etc.

Coating Installation Guide

Coatings Calculator

ADVANTAGES

SURFACE PREPARATION

Surfaces  to receive Epoxy.com Product #1W Epoxy Wall Coating must be clean and sound. Remove all dirt, laitance, grease curing compounds and other foreign matter by sandblasting, mechanical abrasion, or acid etching. Remove water and dust from all surfaces with an oil-free blast immediately prior to application.

MIXING INSTRUCTIONS

Temperature of Product #1W Epoxy Wall Coating must be 50 degrees F or above at time of mixing. Stir each component separately before blending. Mix 4 parts by volume of Part A with 1 part by volume of Part B for three minutes with a low speed electric drill motor equipped with a mixing paddle.

APPLICATION

Apply Product #1W Epoxy Wall Coating with a roller, brush, or spray equipment. Two coats are recommended. Thickness per coat should be 7-10 mils. Seven days cure time is required to reach maximum chemical resistance.

LIMITATIONS

DO NOT apply at temperatures below 40° F. Surface must be dry.

SAFETY PRECAUTIONS

Prolonged or repeated exposure may cause eye and skin irritation. If contact occurs, wash immediately and seek medical help. Use safety glasses with side shields and wear protective rubber gloves.

CLEANING

All tools and equipment should be cleaned before the system gels. Use MEK, Acetone, or any lacquer solvent.

APPLICATION PROPERTIES @77° F

Mix Ratio 4:1 By Volume
Viscosity (mixed) 2000 -2500 CPS
Pot Life (200 gr.) 40-50 minutes
Tack Free to Touch 8 to 10 Hours
Initial Cure 24 Hours
Final Cure 7 Days
Packaging Unit Size 1.25 gal. unit, 5 gallon unit
Standard Colors White, Light Gray, Dark Gray, Taupe, Sand, Old Gold, Mocha, Brick Red, Slate Blue, Colonial Green, Deep Blue, Black, Safety Yellow

Epoxy.com Epoxy Color Chart HereClick the picture of color card below  for a larger version of this picture of the color chart.
Pleasenote:  The picture to the right is a photographic reproduction of the color card for this product.  The photo reproduction process and your monitor and/or printer will change these colors.  This chart is to give you an idea of the colors available and not intended for critical color selections.

TENSILE PROPERTIES

Tensile Strength (ASTM D-638)5500 psi. min.
Elongation4-5%

Other customers who visited this page also visited: